The Build (in review)
I review the components of LoCARB and how they performed after 94 days out in the ocean.
Continue reading
Category: companion computer
The Hail Mary
LoCARB has its main thruster repaired, its solar system loses a charge controller, and LoCARB gets a backup thruster. Also, LoCARB gets launched again.
Continue reading
The tragic second launch
LoCARB was launched the second time, with some useful software upgrades! Also, credit is due where credit is due.
Continue reading
Navigation tuned and ready to go!
Navigation for LoCARB tested and complete, with a top speed clocked at 2 knots…Not a bad speed for being 125lbs!
Continue reading
Arduino Mavlink Library – Monitor the autopilot heartbeat
Monitor a Pixhawk flight controller autopilot with an Arduino using the Mavlink protocol.
Continue reading
Arduino Mavlink Library – Changing flight modes
Use an Arduino to send a mavlink message to the autopilot to change flight/driving mode.
Continue reading
Consolidating with a mini mega and soldered protoboard circuits
Consolidating electronics and plans for if LoCARB is found
Continue reading
Companion computer and tracker programming complete
Finished programming…I think. Whats next? Building and testing the solar power system and the physical boat hull!
Continue reading
Bi-directional satellite communication and messaging!
Finally hooked up my Rockseven Rockblock modem and implemented bi-directional communication!
Continue reading
Small little update
A quick update about KST servos, Rockblock Naked MK2 Sat modem, and LOCARBs electronics progress
Continue reading
