Skip to content

Lo.C.A.R.B.

Home of the Low-Cost Autonomously Run Boat

  • About Locarb
    • About Me
    • F.A.Q.
  • Track LoCARB
    • Captain’s Log
    • Captain’s Log 05/30 – 06/05
    • Captain’s Log 06/06 – 06/12
    • Captain’s Log 06/14 – 06/19
    • Captain’s Log 06/20 – 06/26
    • Captain’s Log 06/27 – 07/26
    • Captain’s Log 08/02 – 08/27
  • The Build
    • The Build (in review)
    • Code and Guides
    • Power System
    • LoCARB gets a new power supply for the refresh
    • From direct drive to magnetic coupling
    • Thinking through selecting a servo for the rudder control system
  • Photo Album
  • Sponsors
  • Contact Me
Lo.C.A.R.B.

Tag: code

Using an Arduino to read RPM from the Hobbywing RPM sensor

Posted on February 11, 2019April 2, 2019 by Adrian Li

Reading RPM using an Arduino and a Hobbywing RPM sensor

Continue reading
Propulsion
5 comments

Translate

en English
ar Arabicbg Bulgarianzh-CN Chinese (Simplified)cs Czechnl Dutchen Englishtl Filipinofr Frenchde Germanhi Hindihu Hungarianit Italianja Japaneseko Koreanlt Lithuanianno Norwegianpt Portuguesero Romanianru Russiansr Serbiansk Slovaksl Slovenianes Spanishtr Turkishuk Ukrainian

Track LoCARB

LoCARB is currently in the middle of the Pacific Ocean. See where it is!

Captain's Log

Notes of anything remarkable during the voyage.

The Build

What electronics make LoCARB go?

Recent Posts

  • The final final end of the LoCARB project
  • Humbled and Amazed!
  • The Build (in review)
  • The Hail Mary
  • Magnetic Coupling Failure and LoCARB Recovered
WordPress Theme: Donovan by ThemeZee.